How to use a manual razor

1. Clean the beard position, clean the razor and hands, and wash the face (especially the part where the beard is located).

2. Soften the beard with warm water and pat some warm water on the face, which can open the pores and soften the beard. Apply shaving foam or shaving cream on the part to be shaved, wait for 2-3 minutes, and then start shaving.

3. The procedure of shaving from top to bottom usually starts from the upper cheeks on the left and right sides, then the beard on the upper lip, and then the edges and corners of the face. The general principle is to start with the thinnest part of the beard and put the thickest part last. Because shaving cream stays longer, Hu Gen can be further softened.

4. Rinse with warm water. After scraping, rinse with warm water. Gently pat the scraped part dry with a dry towel. Do not rub hard.

5. Aftershave care aftershave skin is a little injured, so don't rub it. Still insist on patting your face with cold water at the end, and then use aftershave water or toner, shrink water, aftershave honey and other aftershave maintenance products. Sometimes it may be too heavy, shaving too hard, resulting in bleeding on the face. Don't panic about it. Calm down, apply hemostatic ointment immediately, or press the wound with a small ball of clean cotton or paper towel for 2 minutes. Then, dip a few drops of water with clean paper, gently stick it on the wound, and then slowly remove the cotton or paper towel.

6. When cleaning the blade, remember to wash it and put it in a ventilated place to dry. To avoid bacterial breeding, the blade should be changed regularly. After washing with water, you can also soak it in 75 degree alcohol.