Shaver use and maintenance

The correct use of electric shavers can not only obtain satisfactory shaving effects, but also ensure safe use and extend the service life of electric shavers.

1. Generally, it is not suitable to shave the beard too long. If the beard is too long, it is best to use a combined electric shaver with a trimmer. Or cut the beard roughly with small scissors first, and then use a razor to make the effect better.

2. Dry your face first and then shave. It is best to tighten the skin of the face slightly with your fingers, touch the skin along the direction at right angles to the beard, and gently move the electric shaver by drawing a circle.

3. When installing and disassembling the electric shaver, be sure to disconnect the power supply and stop the motor rotation or electromagnetic vibration, otherwise, there is a danger of being cut. The front end of the inner knife has a sharp edge, special attention should be paid when assembling and disassembling.

4. The cutting edges and pores of the inner and outer knives are easy to hide in the whiskers and dander, and should be used after each use.Try to clean it with a small brush. Since the curing of whiskers and skin oil will hinder the movement and sharpness of the blade, it is necessary to remove the debris remaining on the cutting edge frequently.

5. Because the outer knife is thin, do not push the big knife to avoid deformation. Once the shape changes, it will hinder the inner knife from rotating, or it will cut the skin when used. If the cutting edge is deformed and damaged, it should not be used again, otherwise there will be a risk of cuts.

6. For electric shavers of carbon brush motors, each use time should not be too long. Otherwise, the carbon brush and commutator of the motor will be worn out, so that the rotation force will be weakened.

7. In order to maintain the performance of the battery, it should be used in the range of ambient temperature of 0~40 ℃. When not in use for a long time, the dry battery should be taken out and stored to avoid damage to the internal parts due to leakage.

8. For rechargeable shavers, when charging, the switch should be placed in the off position and charged with the corresponding voltage power supply. After charging, pull out the latch immediately. The Rechargeable Shaver battery, if it is placed for a long time after charging, it will discharge itself, which will reduce the electromotive force. Therefore, when it is placed for more than three months, it should be recharged before it can be used. Continuous charging for more than two days can shorten the battery life, so it should be avoided.

9. Apply a little oil to the inner surface of the outer knife regularly (once a week). Some rotating parts such as inner knife support shafts or motor spindles also need to be lubricated. When refueling, you can drop a small drop of oil on your fingers, then wipe the shaft, or use a small wooden stick to guide the drop, but pay attention to the amount of oil not too much.

10. The switch should be kept clean. If there is too much oil accumulation, it will affect the power-on performance and cause the motor to work abnormally.

11. For shavers that use AC power, avoid using and plugging the plug with wet hands during bathing, otherwise, there will be a risk of electric shock.

12. Open the switch after use. To protect the blade, a protective cover must be put on, then put it in a box, and the razor should be stored in a dry place.

13. Do not use alcohol, banana water or other volatile chemicals to wipe and clean up.